Crivit MR-1442 Manuel d'utilisateur télécharger pdf (Page 23)

23GB

- If you have health problems, consult your

doctor before use of this article. If you feel

unwell during training, stop immediately and

consult your doctor!

- Pregnant women should only use this article

after consultation with a doctor.

- When training, make sure there is enough

space between you and any objects or other

people in order to avoid injury.

- Keep the instructions in the vicinity of the

training apparatus. This could be useful for

reading up on the main exercises.

- Before each use ensure all screwed joints are

tight.

- When using the door bar on the ﬂoor, delicate

ﬂooring such as parquet or laminate may be

damaged. Always use non-slip rugs or mats on

delicate or slippery ﬂoors.

Assembly

You will need drill and a Phillips head

screwdriver for mounting the safety

bracket (11).

Overview of parts (see Fig. A)

- Interconnect the bars (1) and (2) and secure

with the screws (3) / washers (4).

- Then secure the bars (5) and (6) with screws

(7). Place the washers (4) under the nut (8)

and screw tight (see Fig. C).

Note! The following screw connection

has 3 options for connecting the grab

bar (1/2) with the curved grab bars

(6). First use the centre hole. Be sure

to follow the safety notices in chapter

“Assembling to door frames”!

- Now secure the bars (1/2) and (6) using

screws (9) and spacer (10). Please be sure to

place the 28mm cone on the spacer below

the bar (6) and the 32mm cone onto the bar

(1/2). Place the washers (4) under the nuts (8)

and tighten the screw connection (see Fig. D).

Assembling to door frames

ATTENTION! Make sure you use the cor-

rect assembly materials. The assembly

materials enclosed with this article are

suitable for attaching the door bars to

stable concrete walls (see Fig. B).

For attaching to lightweight concrete

walls, please contact your local dealer

and enquire as to the best method of

attachment.

Secure the safety bracket (11) to the back of the

respective door, directly above the door frame

(see Fig. E).

After mounting the safety bracket you may hook

the door bar into the door frame as shown. First

hook the bar (5) into the safety bracket (see Fig.

F). Then press the bar ends (1/2) against the

front door frame (see Fig. G).

Attention!

- Be sure the bar is ﬁrmly hooked into

the safety brackets. Verify the

door bar is securely seated by ﬁrmly

“pulling” and “jiggling” it.

- With the all-purpose door bar hooked

in, the handles of the curved grab bar

must be at an approx. 90° angle to

the wall with the door (see Fig. G).

If the grips point upwards due to the

wall thickness, change the bolting of

the straight grip bar (1/2) and the

bent grip bar (6).

Use the hole which points to the grip

end.

The grip bar points downwards if the

wall with the door is too thin, use the

third hole from the end of the grip.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire